Products
RFTXXA-02TA7265-12.4 Microstrip Attenuator With Sleeve DC~12.4GHz RF Attenuator
| Model | RFTXXA-02TA7265-12.4 (XX=Attenuation value) |
| Resistance Range | 50 Ω |
| Frequency Range | DC~12.4GHz |
| Power | 2 W |
| Attenuation(dB) | 01-10/11-20/30 |
| Attenuation Tolerance(dB) | ±0.5/±1.0/±1.0 |
| VSWR | ≤1.20 @10GHz ≤1.25@12.4GHz |
| Temperature Coefficient | <150ppm/℃ |
| Substrate material | Al2O3 |
| Sleeve Material | Al (Conductive oxidation natural color) |
| Resistance Process | Thick Film |
| Operating Temperature | -55 to +125°C (See de Power De-rating) |
| ROHS Compliant | Yes |
Outline Drawing (Unit: mm/inch)
Diameter tolerance: ±0.05, length tolerance: ± 0.05
Typical Performance:
1dB Graph
3dB Graph
5dB Graph
7dB Graph
9dB Graph
20dB Graph
2dB Graph
4dB Graph
6dB Graph
8dB Graph
10dB Graph
30dB Graph
Use Attention
Power De-rating
1.Elastic contact is used at the contact point between the connector and the sleeve electrode;
2.The inner hole of the radiator should match the diameter of the sleeve, and the tolerance should not be too large;
Operation steps:
A. Tighten one end of the connector with a thread to one end of the radiator;
B. Place the sleeve type attenuation plate into the internal hole of the radiator;
C. Then tighten the connector on the other end with a thread
D. Attention: Thread requires the use of thread sealant
P/N Designation
Notes
■ The sleeve and radiator need to be tightly connected to ensure heat dissipation.
■ Good grounding is required to ensure S parameters.
■ In order to meet the requirements of the drawings,it is necessary to install radiators of sufficient size.
■ If necessary, increase air cooling or water cooling.
■ The connection between the connector and the sleeve type attenuation electrode must use elastic contact.
■ If the sleeve is marked with "IN", be sure to place one end of the IN on the input port, and if there is no label, it will be bidirectional.
◆Remarks:
■ We can provide customized RF attenuators, RF resistors, coaxial dummy(termination) loads, and mismatched dummy(termination) loads.
